Finish lumber
maple board 1 × 8 × 12 ft
Verify the exact product technical data.
Good choice when…
A good candidate when use, exposure, dimensions and every system component match the documentation.
Avoid when…
A poor candidate when compatibility must be improvised, damage hidden or a regulated component replaced without validation.
Reference data
| Purchase unit | piece |
|---|---|
| Nominal size | 1x8 |
| Length | 12 ft |
What the numbers mean
- Stated nominal size: 1x8; measure actual size before designing the joint or support.
- Stated retail length: 12 ft; check usable length and transport.
Recommended uses
- For trim, shelving, cladding, furniture and non-structural details in a compatible environment.
- For visible locations where appearance, profile, paint or stain acceptance and stability matter.
- For assemblies that can be acclimated, cleanly cut and fastened without splitting edges.
Specific uses linked to this sheet
- Trim and interior finish in an environment suited to the product.
- Shelves with span and supports selected for the load.
- Furniture and non-structural assemblies after acclimation.
When to avoid this material
- Do not use as a load-bearing member unless explicitly graded and designed for that use.
- Avoid wet or exterior areas when the species, adhesive or profile is not intended for exposure.
- Avoid pieces whose grain, knots or warp will compromise the visible joint.
Compatibility and installation
- Test primer, stain, adhesive and filler on scrap before treating all pieces.
- Acclimate as directed and leave the required seasonal movement gaps.
- Match nails, screws, adhesive and predrilling to material thickness and hardness.
Storage, care and service life
- Store flat and dry, and acclimate in the room before final cutting.
- Clean with a finish-compatible product; repair leaks and chips promptly.
- Keep a labelled offcut for future repairs and finish colour matching.
Common mistakes
- Cutting every piece to the same length without accounting for out-of-square corners and walls.
- Finishing only the visible face where moisture can reach backs or ends.
- Forcing a joint with nails instead of correcting the cut and backing.
Alternatives to compare
- Compare solid wood, finger-jointed stock, MDF, PVC and plywood for moisture, finish and repairability.
- A stock profile may cost less than custom fabrication after finishing time.
Before purchase
Confirm exact size, coverage, certification, compatibility, lot and instructions. This sheet helps you ask the right questions; it does not make two similar products equivalent.